0497 74 99 32
Current language : EN
Free quote
Current language : EN
Request a free quote 0497 74 99 32
Flat-roof waterproofing in Wavre
1300 · Walloon Brabant

Flat-roof waterproofing
in Wavre

Multi-layer bituminous waterproofing on a flat roof: garage, outbuilding, extension, non-accessible terrace. We do it in Wavre from our base in Walloon Brabant, always with an on-site pricing visit before anything is committed.

Quote in Wavre

Reply within 48 working hours. No obligation.

Or call us directly on 0497 74 99 32.

Flat-roof waterproofing in Wavre
Flat-roof waterproofing — a typical job in Walloon Brabant.

The context in Wavre

Why here in particular

What changes in Wavre is the context: brick terraced houses in the centre, detached villas on the outskirts, plenty of concrete-tile roofs laid in the 1970s. The valley floor stays damp for much of the year: north-facing slopes take moss faster than elsewhere and the bottom of the facades shows it.

A flat roof almost never leaks in the middle. It leaks at the upstands, at the corners and around the roof outlet — where the old membrane was badly turned up or has ended up shrinking back.

Quote
Priced after a site visit, free of charge and with no obligation.
Duration
1 to 3 days for a standard surface.
Call-out
Included in Wavre and neighbouring municipalities

How it runs

How the job runs

The same protocol everywhere, adapted to what the visit reveals on site. Nothing is decided from the pavement.

  • Survey of what is there
  • Removal and disposal if needed
  • Vapour barrier and insulation to suit the configuration
  • Two-layer torched waterproofing
  • Upstands, flashings and edge trims
  • Roof outlet and overflow checked
  1. Probing

    We check what is under the membrane. Waterlogged insulation gets replaced, not covered over.

  2. Removal or overlay

    Depending on the condition, full removal or fitting over the existing layer if the substrate allows.

  3. Vapour barrier and insulation

    If the roof is insulated, PIR or wool depending on the configuration.

  4. Undercoat

    First layer, self-adhesive or torched, with staggered joints.

  5. Finish

    Top membrane torched on, mineral-finished or smooth depending on exposure.

  6. Measurements and waste removal

    Upstands round the perimeter, outlet spigot, water test verified.

Frequently asked questions

Flat-roof waterproofing in Wavre

The questions we get asked most often before this kind of job.

Do you attend leaks as an emergency?

Yes, a temporary repair first to stop the water, then costing the permanent repair calmly.

How long does flat-roof waterproofing last?

A two-layer system laid properly lasts 20 to 25 years. A single layer laid in a hurry lasts a lot less.

Can you lay over the old flat-roof waterproofing?

If the surface is dry and sound, yes. If the insulation is waterlogged, no: the problem would come back from underneath.

Do you come out to Wavre with no extra call-out charge?

Yes. Wavre is one of our 17 municipalities: the call-out is included in the quote, not added at the bottom of the invoice.

Flat-roof waterproofing in Wavre: let’s talk about it

On-site visit, detailed costing within 48 working hours, with no obligation on your part.

CallFree quote